First Setup Of Digital Thermostats - Uponor smatrix space Installation And Operation Manual

UK
6.8

First setup of digital thermostats

CZ
Select thermostat control mode
If an external sensor is connected to the thermostat,
a control mode must be selected to accommodate the
DE
extra functionality of the sensor.
N O T E !
DK
If no button is pressed for about 8 seconds,
while in a submenu, the current values will be
saved and the software exits to the settings
EE
menu. About about 60 seconds later, it exits
to run mode.
1. Press and hold the OK button until the settings
ES
icon and menu numbers is displayed in the top right
corner of the display (about 3 seconds).
FI 2. Use buttons - or + to change the numbers to 04
and press OK.
3. Current control mode is displayed (RT, RFT, RS or
FR
RO).
4. Use buttons - or + to change control mode (see list
below) and press OK.
HR
RT = Room temperature
RFT = Room temperature with external floor sensor
HU
RS = Remote sensor
RO = Room temperature with remote outdoor
sensor*
IT
*) For display of outdoor temperature only.
5. Press and hold the OK button for about 3 seconds
LT
to exit the settings menu.
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 8
Temperature setpoint
The thermostats are delivered with a default setpoint of
21 °C (may differ depending on heating mode).
The illustration below shows how to adjust the
thermostat temperature setpoint.
To adjust the thermostat temperature setpoint of the
current control mode:
1. Press the - or + button once.
2. Press the - or + button repeatedly to adjust the
U P O N O R S M AT R I X S PA C E / S PA C E P L U S · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
The screen shows the current setpoint flashing.
T-166 T-168
setpoint temperature. It will change with increments
of 0.5.
When the new setpoint is set, the screen returns to
run mode after a few seconds, showing the room
temperature.