Installation Example - Uponor smatrix space Installation And Operation Manual

4.3

Installation example

X-161 T-165
230 V
Option
Option
See also the wiring diagram in the end of the manual.
Caution!
Only 230 V actuators are compatible with the
controller.
N O T E !
Only one thermostat can be registered to the
controller.
U P O N O R S M AT R I X S PA C E / S PA C E P L U S · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
T-166
T-168
Option
Option
Uponor Smatrix Space system
A connection example of Uponor Smatrix Space
Controller (single channel) using one of the thermostats
as shown in figure.
The installation will work in a standard way with the
thermostat regulating the room according to its set
temperature.
Thermostat (heating) and actuator (T-165 only)
• The thermostat controls the actuator, regulating the
room temperature using only the setpoint value.
Thermostat (heating and cooling) and actuator
(T-166 or T-168 only)
• The thermostat controls the actuator, regulating the
room temperature using the setpoint value, offset
temperatures and scheduling (T-168 only).
• A signal is sent to an external heating/cooling
product (third-party product, just schematic
example in illustration), such as a 3-way switch over
valve.
Option (T-166 or T-168 only)
• External temperature sensor.
• Floor temperature sensor.
Schedules (T-168 only)
Programmable schedules can, during heating and/or
cooling, switch between Comfort and ECO mode. See
example below.
Schedule
Comfort
ECO
night morning
0 h 00 6 h 00 12 h 00
Heating/cooling switch (T-166 or T-168 only)
The heating/cooling switch is controlled through the
menu system of the digital thermostat. It is used to
switch the operation of the controller between heating
and cooling modes.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
afternoon night
18 h 00 24 h 00
NL
NO
PL
PT
RO
RU
SE
SK
1 1