Assign Screen; Adjusting The Send To Aux Level - Yamaha TF5 Reference Manual

3
Pre button
Allows you to select whether the pre-fader or post-fader signal is sent to the
corresponding AUX bus.
On: Before the fader
Off: After the fader
4
Send pan slider
Displayed for stereo AUX buses. Allows you to adjust the pan of the signal sent to the
corresponding AUX bus.

Adjusting the SEND TO AUX level

1. Adjust the level sliders as desired.
Each level slider determines the amount of signal sent from
the selected channel to the corresponding AUX bus.
2. Turn the Pre button on or off depending on your
needs.
Send the pre-fader signal when using the AUX bus for on-stage floor monitors—this allows you to
create a mix that is separate from the main mix.
Send the post-fader signal when using external effects processors or when you want to maintain the
same mix balance as the main mix.
3. Turn the send button on or off.
When turned on, the signal is sent to the corresponding AUX
bus.
4. Touch the send pan slider and then adjust it using the [TOUCH AND TURN] knob.
When sending the signal to a stereo AUX bus, you can adjust the pan of the signal that is sent.

ASSIGN screen

Allows you configure recall safe and mute safe settings, DCA group assignments, signals sent to
the SUB bus, etc.
1
Recall Safe button
Turns Recall Safe on and off for the corresponding channel.
You can display the RECALL SAFE screen by touching the jump button in the right corner
of the Recall Safe button.
2
Mute Safe button
You can temporarily exclude certain channels from a mute group.
If you mute a mute group, any channels in that group that have mute safe enabled will
not be muted.
3
ST button
Turns the channel's assignment to the stereo channel on and off.
4
SUB button
Determines whether the channel's signal is sent (on) or not sent (off) to the SUB bus.
5
SUB level slider
Determines the amount of signal sent from the selected channel to the SUB bus.
6
DCA buttons
Turns the channel's assignment to each DCA group (1–8) on and off.
You can assign a channel to multiple DCA groups if desired.
- 58 -
Configuration screens
(page 23)
TF Series
Reference Manual