Output Port Trim Screen; Fader Calibration Screen - Yamaha TF5 Reference Manual

Output Port Trim screen

Allows you to adjust the gain of each OMNI OUT jack in 0.01 dB increments.
1
OMNI OUT jack selection buttons
Select the OMNI OUT jack that you want to configure here.
Select the button that corresponds to the OMNI OUT jack you want to configure, and
then use the [TOUCH AND TURN] knob to adjust the value.
After making adjustments, start up the console as usual.
2
Reset All button
Resets all values to 0.00 dB. The factory default setting is also 0.00 dB.
Touch to display the confirmation message. Touch the OK button to perform the
operation.
NOTE
• When the reset is complete, you can continue to use other maintenance features without exiting.

Fader Calibration screen

In some usage environments, discrepancies may occur in the motion of the motor faders. You
can use this screen to correct these discrepancies
1
START button
Starts the calibration.
Touch to display the confirmation message. Touch the OK button to perform the
operation.
2
Cancel button
Stops the calibration.
3
Apply button
Applies the settings and exits.
- 74 -
Maintenance screen
TF Series
Reference Manual