MobileDemand T1400 User Manual page 62

The GPS application cannot find my
location.
No sound is produced.
I cannot project the xTablet T1400
display to another monitor.
Barcode scanner does not emit light and
does not seem to work.
Barcode Scanner emits light but does
not read barcode presented to it.
xTablet T1400 User Guide
xTablet T1400 Users Guide
58
 Make sure that the distance between the
two devices is within 10 meters and there
are no walls or large obstructions
between the devices.
 Make sure the both devices are turned on
and configured to be discoverable.
 Make sure that both devices are
compatible.
 If just starting the tablet from power off, it
may take several minutes for signal to be
acquired.
 Make sure that GPS is turned on in Hot-
Tab.
 Make sure that GPS receiver and the
location sensor are enabled in Control
Panel.
 The xTablet T1400 may be out of
coverage area. Move your xTablet T1400
outdoors or closer to a window.
 Check if your surroundings have
interference, such as microwave ovens,
cordless phones. Move the xTablet T1400
away from objects causing interference.
 Adjust volume of the xTablet T1400 by
pressing on the volume rocker.
 If using an external audio device, make
sure that the cable is properly connected.
 Make sure the HDMI driver is installed.
 Make sure the output setting selected is
correct.
 Make sure the Barcode scanner device is
enabled in Hot-Tab utility.
 Adjust the distance between barcode
scanner of the device and the barcode
being scanned.
 Make sure the barcode code type is
enabled in the tablet. To enable/disable a
specific barcode code type, go through
the "Barcode Scanner Configuration"
section.
 Clean the scanner lens with a damp clean
cloth.