Preparations For Wet Grinding; Manoeuvring Via The Control Panel - HTC 800 RX Manual

Usage
7. Turn on the Mist-Cooler by turning the control (position 5 Figure 3-2, page 11)
to "ON".
8. Switch off the Mist-Cooler by turning the control (position 5 Figure 3-2, page
11) to "OFF" when grinding is finished.
9. Turn the tap to the closed position when grinding is finished.
4.10

Preparations for wet grinding

1. Always use liquid suction when wet grinding.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine.
4. Set the handle to the working position, see Figure 4-2, page 17.
5. Fill the tank with cold water.
6. Turn the tap on the left side of the machine to the open position, position 9
Figure 3-2, page 11.
7. Turn the tap to the closed position when wet grinding is finished, position 9
Figure 3-2, page 11.
4.11

Manoeuvring via the control panel

Tip!
Drive the machine manually in difficult to navigate spaces.
During manual driving, the operator pushes the machine forwards across the floor
surface and manoeuvres it via the control panel, see Figure 3-3, page 12.
26
Tip!
Never use a dust extractor, as blockages may develop in the dust
extractor's suction hose and filter.
Warning!
Only use cold water with no chemical additives.
HTC 800 RX
2.0