Page 1
Installation Manual MManualManual Set up and user manual for the VVRD28V12CM960H / U VVRD28V12DN960H / U VVRD28V12DNLED960H / U Cameras...
Page 3
Before You Begin Read these instructions before installing or operating this product. Note: This installation should be made by a qualified service person and should conform to local codes. This manual provides installation and operation information. To use this document, you must have the following minimum qualifications: ...
Page 4
This apparatus is manufactured to comply with the radio interference. A Declaration of Conformity in accordance with the following EU standards has been made. The manufacturer declares that the product supplied with this document is compliant the provisions of the EMC Directive 2004/108/EC, the CE Marking Directive 93/68 EEC and all associated amendments.
IMPORTANT SAFEGUARDS 1. READ AND RETAIN INSTRUCTIONS Read the instruction manual before operating the equipment. Retain the manual for future reference. 2. CLEANING Turn the unit off and unplug from the power outlet before cleaning. Use a damp cloth for cleaning. Do not use harsh cleansers or aerosol cleaners. 3.
12. SERVICING Do not attempt to service the video monitor or equipment yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 13. DAMAGE REQUIRING SERVICE Unplug the equipment from the wall outlet and refer servicing to qualified service personnel under the Following conditions: A.
CONTENTS OF PACKAGE Installation of the camera must be performed by qualified service personnel in accordance with all local and national electrical and mechanical codes. Carefully remove the colour camera and its accessories from the carton and verify that they were not damaged in shipment. The content of the package includes: 1.
Adjusting Camera Module TACT SWITCH OPERATION The tact switch allows both navigation and changes to the OSD Menu. To enter into the OSD menu push centrally on the joystick and navigate using the up, down, left and right actions. If there is an arrow to the right of the menu function, this denotes that there is an accessible sub menu function.
OSD MENU STRUCTURE SETUP MENU (page 1) LENS SHUTTER/AGC LANGUAGE LENS AUTO IRIS AUTO SHUTTER/AGC MANUAL MANUAL WHITE BAL BACKLIGHT PICT ADJUST RETURN RETURN NEXT (page2) EXIT SAVE ALL WHITE BALANCE BACKLIGHT PUSH USER 1 USER 2 ANTI CR MANUAL PUSH LOCK RETURN RETURN...
Page 12
SETUP MENU (page 2) MOTION DET PRIVACY DAY/NIGHT PRIVACY DAY/NIGHT AREA SEL AUTO COLOUR COLOUR CAMERA ID TRANSP CAMERA RESET MOSAIC BACK (page 1) EXIT SAVE ALL RETURN RETURN CAMERA ID LANGUAGE CAMERA RESET NR MODE (titling) ENGLISH RETURN Y LEVEL GERMAN (return the C LEVEL...
Page 13
LENS Manual Manual lens only Auto Type: DC, Video (Sets the type of lens and whilst Video is selectable, it is not supported on this model) Mode: Open, Close, Auto (Sets the type of control applied over the mechanical iris) Speed: 0 - 255 (increments of 1) Sets the convergence speed of the mechanical iris.
WHITE BAL Modes: ATW, Push, User1, User2, Anti CR, Manual, Pushlock (Adjusts the white balance to suit area being viewed) ATW (Auto Trace White balance) Speed: 0 to 255 (increments of 1) (Adjusts the pull in speed of ATW) Delay Cnt: 0 to 255 (increments of 1) (Sets the time-based hysteresis of ATW) ATW Frame: x0.5, x1.5, x2 (Sets the pull in frame magnification)
PICT ADJUST Mirror: Off, on (horizontally inverts image). 0 – 255 (increments of 1) Brightness: 0 – 255 (increments of 1) Contrast: 0 – 255 (increments of 1) Sharpness: 0 – 255 (increments of 1) Hue: 0 – 255 (increments of 1) Gain: (in all of the above, the smaller the number, the darker or lower the setting that is applied)
Page 16
PRIVACY PRIVACY: allows upto 8 masks to be applied to the image (note that if motion area in motion det menu is set to ‘on’, this reduces to 4 privacy zones) Area Sel: 1 - 8 (Selects the motion detection area) Top: 0 –...
Page 17
B/W: Monochrome only operation Burst: Off, On (Allows the colour burst signal in monochrome to be removed if required) IR Optimizer: Off, On (if On, then Mode & Level are adjustable) Mode: Auto, Centre Level: 0 – 31 (increments of 1) Ext 1: Switches to permanent mono mode and reflects the setting in B/W mode Ext2 (auto switching between colour&...
SYNC This is fixed within the camera and non-adjustable. LANGUAGE LANGUAGE select between: English (EN), German (DE), French (FR), Russian (RU), Portuguese (PT) & Spanish (ES). CAMERA RESET CAMERA RESET - Returns the camera to the factory default settings. EXIT / SAVE ALL EXIT –...
DEAD PIXEL CORRECTION It is perfectly normal for a camera CCD to have what is known as ‘dead’, ‘hot’ or ‘white’ pixels, develop over time and on occasion and these can be noticeable on the viewed image. These can be masked easily without affecting the quality of the image, with the DPC function.
SPECIFICATIONS VVRD28V12-960H Model DNLED Resolution 700TVL (colour and monochrome) 1/3″ SONY Super HAD (960H) Image sensor Sony Effio E II Total pixels 1020(H) x 596(V) Effective pixels 976(H) x 582(V) Scanning Syst. 2:1 Interlace Scanning Freq. PAL: 15.625KHz(H) x 50Hz(V) Sync.
Page 22
VVRD28V12-960HU Model DNLED Resolution 700TVL (colour and monochrome) 1/3″ SONY Super HAD (960H) Image sensor Sony Effio E II Total pixels 1020(H) x 596(V) Effective pixels 976(H) x 582(V) Scanning Syst. 2:1 Interlace Scanning Freq. PAL: 15.625KHz(H) x 50Hz(V) Sync. system Internal 1.0Vp-p (75Ω, composite) &...
Page 24
VVRD960H_U Manual / V1.0 / 2013-02-22 (subject to change without notice)