Warnings And Cautions When Using - Hitachi SK-HD2200 Operating Instructions Manual

Warnings and cautions when using

CAUTION
Power supply
The specified power supply input voltage of this
camera is 12VDC. Be sure to use the designated
power supply.
Do not disassemble or modify
The camera contains
components. Do not open the cover or disturb
switches and controls other than designated.
There is risk of impaired performance and
damage.
Keep foreign object out of interior
Entry of water, metallic or other foreign
materials can cause failure and damage.
Select use and storage locations carefully
Avoid using or storing the equipment in the
following types of
performance and damage can be caused.
Extremely hot or cold locations (exceeding -10
to 45°C), such as in enclosed vehicles.
Subject to strong vibration.
Humid or dusty locations.
Salt spray or corrosive gases.
Strong electromagnetic fields (e.g., near TV or
radio transmitters).
Where exposed to rain.
Do not cover or otherwise obstruct camera
heat dissipation during operation.
NOTE
The following types of phenomena are innate characteristics of a charge coupled device (CCD) and are
not malfunctions. Be aware of these when using a CCD camera for broadcast or other demanding
applications.
precision internal
locations. Impaired
**********CCD characteristic phenomena**********
Smear
When a bright object is picked up, thin trails appear above and below the
image.
The effect is more pronounced at high electronic shutter speeds.
Fixed pattern
When operate at high temperature, a fixed pattern (vertical stripes,
white dots) can appear. The pattern is more easily seen when the
camera sensitivity is raised.
Viewfinder high voltage
Do not open the viewfinder cover.
danger of touching internal high voltage
components.
When connecting
microphone and
connector by the body, not the attached cable.
Cables can be damaged by pulling on them.
Note when transporting
When transporting by hand, use the carrying
case. If shipping by truck or other means, pack
in the carrying
cushioning and pack in a sturdy carton.
Tripod
Use a recommended tripod and install the
camera correctly.
Cleaning
Use a photographers air blower to clear dust
from the lens and filters. Wipe the case with a
soft dry cloth. Do not use volatile solvents, as
these may deform the materials.
In event of difficulty
Disconnect from power and contact the nearest
Hitachi Kokusai Electric service agency.
3
WARNING
There is
CAUTION
and disconnecting
other cables, grasp
case, then use
lens,
the
further