Primary Ide Master - Asus TW510-E2 Service Manual

While entering Setup, the BIOS automatically detects the presence of
IDE devices. There is a separate sub-menu for each IDE device. Select a
device item then press <Enter> to display the IDE device information.
5.3.6 5.3.6 5.3.6 5.3.6 5.3.6

Primary IDE Master

Primary IDE Master Primary IDE Master Primary IDE Master Primary IDE Master
Main
Primary IDE Master
PIO Mode
UDMA Mode
Primary IDE Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Transfer Mode
S.M.A.R.T Status
↑↓ ↑↓ ↑↓ ↑↓ : Select Item ↑↓
F1:Help
→←: Select Menu →← →← →← →←
ESC: Exit
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Precomp, Landing Zone, Sector, and Transfer
Mode, and S.M.A.R.T Status). These values are not user-configurable. These
items show "0" or "None" if no IDE device is installed in the system.
PIO Mode PIO Mode
PIO Mode PIO Mode PIO Mode
Sets the PIO mode for the IDE device. The settings Mode 0 to 4 allow
successive increase in performance. Configuration options: [Auto] [Mode 0]
[Mode 1] [Mode 2] [Mode 3] [Mode 4]
UDMA Mode UDMA Mode UDMA Mode
UDMA Mode UDMA Mode
When this item is set to [Auto], the UDMA capability allows improved
transfer speeds and data integrity for supported IDE devices.
Configuration options: [Disabled] [Auto]
Primary IDE Master [Auto] Primary IDE Master [Auto]
Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the BIOS automatically fills in the correct values for
the remaining fields on this sub-menu. If the hard disk was already formatted
on a previous system, the BIOS may detect incorrect parameters. Select
[Manual] to manually enter the IDE hard disk drive parameters. Refer to the
next section "Manually detecting an IDE drive." If no drive is installed select
[None]. Configuration options: [None] [Auto] [Manual]
A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2
A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2
Phoenix-Award BIOS CMOS Setup Utility
[Auto]
[Auto]
[Auto]
[Auto]
0 MB
0
0
0
0
0
None
None
-/+: Change Value
Enter: Select Sub-menu
Select Menu
Item Specific Help
Set a PIO mode for the
IDE device. Mode0 through
4 successive increase in
performance.
F5: Setup Defaults
F10: Save and Exit
5 - 1 7 5 - 1 7
5 - 1 7 5 - 1 7 5 - 1 7