Table of Contents
Advertisement
Tally Dascom DT-210/230
The commands listed below in the first column are defined as "obsolete commands" in the ESC/POS
command system.
This printer supports both upward‐compatible commands and obsolete commands. However, the
upward‐compatible commands are recommended to use.
Obsolete command
ESC i
Partial cut (one point left uncut)
ESC m Partial cut (three points left uncut)
ESC u
Transmit peripheral device status
ESC v
Transmit paper sensor status
FS p
Print NV bit image
FS q
Define NV bit image
GS v 0 Print raster bit image
"Obsolete commands" are commands that are supported by legacy models; however it is
recommended to replace them with upward‐compatible commands, because they will not
be supported in the future products.
Upward‐compatible command
GS V
GS V
GS r
GS r
GS ( L <Function 69>
GS ( L <Function 67>
GS ( L <Function 112 + 50>
51
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DT-210 and is the answer not in the manual?