Download  Print this page

Miele PW 5065 Operating Manual Page 61

Miele washer operating manual pw 5065.
Hide thumbs

Advertisement

Table of Contents
Rinse water
The water type for the rinse cycle can
be selected for the "COTTONS" and
"MINIMUM IRON" programs. The hot
water intake will be only accessible at
a wash temperature of 122°F (50°C) or
higher.
The machine comes factory set with the
water type "hot" selected.
Low Water Pressure
With generally low water pressure
(under 100 kPa) this option can be
activated to obtain better water intake.
The machine comes factory set with this
option "off".
COTTONS water level
The program "COTTONS" allows you
to increase the water level for the main
wash.
The machine comes factory set with the
option Block Parameter selected. (The
water level will be controlled according to
the factory set program data.)
MINIMUM IRON water level
The program "MINIMUM IRON" allows
you to increase the water level for the
main wash.
The machine comes factory set with the
option Block Parameter selected. (The
water level will be controlled according to
the factory set program data.)
Menu Settings - Supervisor level
Temperature pre-wash
For the programs "COTTONS" and
"Grease and fat +" the pre-wash
temperature can be selected.
The machine comes factory set with the
option Block Parameter selected. (The
temperature will be controlled
according to the factory set program
data.)
Pre-wash duration
The wash time for the pre-wash can
be extended.
The machine comes factory set with the
option Block Parameter selected. (The
wash time will be controlled according
to the factory set program data.)
COTTONS duration
The program "COTTONS" allows you
to extend the wash time for the main
wash.
The machine comes factory set with the
option Block Parameter selected. (The
wash time will be controlled according
to the factory set program data.)
61

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments:
  • Nick Taylor Jul 27, 2013 08:57:
    I have a PW 5065 that is showing the message "Powe​r Failure. Program stopped&qu​ot; on the LED screen. If you "OK&q​uot; it a new message comes up "cann​ot change the program&qu​ot; and I can't get rid of this issue, and it seems the manual doesn't cover this problem?