Hot water connection
Connecting the machine to a hot water
supply will lead to low electrical
consumption during hot water
operation. The hot water temperature at
the water faucet must not exceed 158°F
The water in single water lines from the
hot water source cools faster when not
in constant use. To heat the wash water
more electricity must be used. The
same conditions for the hot water as for
the cold water connection will then
^ Connect the hot water intake hose
(red mark) to the water faucet.
The connection of the machine to a
hot water line only, is not possible for
If the washer is not to be installed for
hot water connection, the settings "Main
wash", "Pre-wash" and "Rinses" must be
adjusted respectively. The hot water
intake hose must be removed.
^ Select in "Settings - Supervisor level"
the respective options "cold".
The program times may be
^ Unscrew the hot water intake hose
^ Screw on the supplied stopper.