Table of Contents
Advertisement
Troubleshooting
Problems
Printing or platform cannot
reach target temp or over
heat.
Cannot extrude plastic
Cannot detect the printer
1.Initialize the printer.
2.Heater catridge is broken, seek replacement.
3. Cable is broken, replace the cable.
1. Plastic clog the nozzle, replace new nozzle or remove
the clog.
2. The filament is too thick. Usually happens when using
filament with poor quality.Please use UP filament.
3. For some model, if PLA consistently cause problem,
switch to ABS.
1.Install the printer driver correctly.
2. Check for defective USB cable.
3. Restart printer and Computer
26
Solution
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the UP mini and is the answer not in the manual?