Setting The Poe Mode On A Port; Enabling/Disabling Pd Compatibility Detect - 3Com 400 Family Configuration Manual

70 C 4: P
HAPTER OWER OVER
Setting the PoE Mode on
a Port
Enabling/Disabling PD
Compatibility Detect
E C
THERNET ONFIGURATION
Table 69 Setting the Power Supply Management Mode on the Switch
Operation
Set the power supply management mode on the
Switch to auto
Set the power supply management mode on the
Switch to manual
Restore the default power supply management mode
on the Switch
By default, the power supply management mode on the Switch is
Setting the Port Priority
Set the priority of the current port in Ethernet Port View.
Table 70 Setting the Port Priority
Operation
Set the port priority
Restore the port priority
By default, the port priority is low.
Set the PoE mode on the current port in Ethernet port view.
Table 71 Setting the PoE Mode on a Port
Operation
Set the PoE mode on a port
Restore the default PoE mode on the port
By default, the power supply mode on port is by signal lines.
Currently, the Switch 4500 does not support the
supports the mode, a conversion will be needed.
spare
The PD compatibility detect function allows the switch to detect PDs noncompliant
with the 802.3af standard and then supply power to them. You can use the
following commands to enable/disable the PD compatibility detect function.
Perform the following configuration in System View.
Table 72 Enabling/Disabling the PD Compatibility Detect
Operation
Enable the PD compatibility detect
Restore the default PD compatibility default setting
By default, the PD compatibility detect function is disabled.
Command
poe power-management auto
poe power-management manual
undo poe power-management
auto
Command
poe priority { critical | high |
low }
undo poe priority
Command
poe mode { signal | spare }
undo poe mode
mode. If a PD only
spare
Command
poe legacy enable
undo poe legacy enable
.