Sending The Information To Telnet Terminal Or Dumb Terminal - 3Com 400 Family Configuration Manual

250 C 12: F S
HAPTER ILE
Sending the Information
to Telnet Terminal or
Dumb Termina
M
YSTEM ANAGEMENT
Table 285 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
4 Enable terminal display function
To view the output information at the control terminal, you must first enable the
corresponding log, debugging and trap information functions at the Switch.
For example, if you have set the log information as the information sent to the
control terminal, now you need to use the
enable the terminal display function of log information on the Switch, then you
can view the information at the control terminal.
Perform the following operation in User View:
Table 286 Enabling Terminal Display Function
Operation
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information
To send information to a Telnet terminal or dumb terminal, follow the steps below:
l
1 Enabling info-center
Perform the following operation in System View.
Table 287 Enable/Disable Info-Center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to Telnet terminal or dumb terminal
Perform the following operation in System View.
Table 288 Configuring to Output Information to Telnet Terminal or Dumb Terminal
Operation
Output information to Telnet terminal or dumb
terminal
Cancel the configuration of outputting
information to Telnet terminal or dumb terminal
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap
| debugging }
terminal logging
Command
info-center enable
undo info-center enable
command to
Command
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Command
info-center monitor channel {
channel-number | channel-name }
undo info-center monitor
channel