Table of Contents
Advertisement
2.
Handling / Introduction
2.1 General advice
• For cleaning the instrument please do not use abrasive cleaner but a dry or wet piece
• Please store the measuring instrument in a dry and clean place.
• Avoid any force like shocks or pressure to the instrument.
• Do not use force to connect the probe or interface plugs in. The interface plug differs
þ
• If no sensor is connected to the instrument while switching on
2.2 Operation
2.3 Switching on and off
By operating the ON/OFF-key the instrument will be switched on or off.
After switching on the instrument indicates a full segment test for 1,5 sec.
Afterwards the instrument shows the calibration-code and the adjusted measurement category for
channel 1 (e.g.
In the following the calibration data of the second channel (if available) will be shown.
Fig 1: Example of channel information after switching on:
1
1 5 E 4
E E D a
8
of cloth.
from the probe.
indicated on the display (
[
for standard distinguishing line and P for Pt100).
m E E
Channel-1 calibration based on the calibration code of the probe..
O
Handling / Introduction
chapter 4 Error codes )
þ
Please kindly check if the provided mains plug unit is working
properly with your power supply,. The standard equipment is for
230V; 50/60Hz power supply. If your mains supply a different
voltage, you need the universal (all) mains unit (90-260V;
50/60Hz). Please connect first the measuring device with the
suitable mains plug unit (see picture on the back side of the
device) and then connect the mains plug with the mains supply
socket. (
3 Power supply).
þ
The measuring probe 1 is firmly connected to CH 1.
If you would like to connect a second measuring probe: Plug the
second probe into the socket CH 2 of the measuring device. The
connection sockets on the housing are marked accordingly a
CH 2, RS 232 or Analogue Out.
DigiCal DCS 2
„
"
will be
m O D l
YAME0017/09.10.03
Advertisement
Table of Contents
