Selection / Channel Activation - B G L I - Lauda DCS2 Operating Instructions Manual

DigiCal DCS 2
2.4.5 Selection / Channel activation -
To activate or deactivate a measuring channel press [ENTER/MENUE]. Use the up and down keys
[ ] to select
small 1, which indicates the selected channel. For changing the channel use the up and down keys
[ ]. Press [ENTER/MENUE] to confirm. The second display line shows
for deactivation. Use the up and down keys [
requested measuring channel and press [ENTER/MENUE] to confirm.
Press [ESC] to get back to the measuring mode.
− In case that one channel would not be connected to a probe, the main display would
− There must be at least one active channel!
Display
B g l i
1
B g l i
B g l i
2
1
B g l K
1
B g l i
m l
m E E
YAME0017/ 09.10.03
and press [ENTER/MENUE]. On the left corner of the display appears a
B g l K
indicate in the relevant line.
m O D l
Keys
ENTER/MENUE
up and down keys [
ENTER/MENUE
up and down keys [
ENTER/MENUE
ESC
B g l i
] again to activate
Function
select the channel 1 or 2
]
activation or deactivation
]
To keep the amended value
To escape without retention
Handling / Introduction
for activation or
m l
or deactivate
m l m E E
m E E
the
15