Calibration By Physical Standard References - M O 1; Din-Ccalibration Din Iec 60751 - Lauda DCS2 Operating Instructions Manual

DigiCal DCS 2
2.4.3.2 Calibration by physical standard references -
Use the up and down keys [
of the display appears
calibration use the up and down keys [
Example of a 1-Point calibration:
Press [ENTER/MENUE] to confirm. On the display appears
stabile press [ENTER/MENUE]. App. 2 seconds later in the first display line appears
value 1); in the second display line appears
Use the up and down keys [
= two decimal digits
c S
= one decimal digit (decimal point is jumping one digit to the right)
c O -
Press [ENTER/MENUE] to confirm. On the second line of the display appears
down keys [
_
= reference standard shows a negative measuring value (below 0.00C°)
R h
_
= reference standard shows a positive measuring value (above 0.00C°)
R h
Press [ENTER/MENUE] to confirm. On the second line of the display appears
down keys [
= below 100,00°C
E c /
= above 100,00°C
E c 0
Press [ENTER/MENUE] to confirm. Now the display shows
temperature of your reference. To modify the value use the up key [
number use the down key [
If the requested value is complete then press [ENTER/MENUE].
Press [ESC] to get back to the measuring mode.
Important!
A break of the physical calibration
instrument can only do a break of the physical calibration.
2.4.3.3 DIN IEC-Calibration DIN IEC 60751 -
Use the up and down keys [
Press [ESC] to be back in the measuring mode.
YAME0017/ 09.10.03
] to select
. To select between a 1-Point
0 O
] to select the number of digits after decimal point:
]to select the requested sign:
]to select the requested range:
].
cannot be done by the [ESC]-button. Switching off the
m O 1
Display-indication with active calibration code
The
B @ K
that
m O 1
[
] to select
Handling / Introduction
m O 1
. Press [ENTER/MENUE] to confirm. On the bottom
m O 1
[ ]
0 O
].
. After the displayed measuring value is
5 m
. (standing for decimal point).
c O
/ / - / /
– segment and the small 2 on the left indicates to the user
is activated.
m E E
[
. Press [ENTER/MENUE] to confirm.
m E E
[ ]
, a 2-Point or 3-Point
1 O
O 0
_
. Use the up and
R h
. Use the up and
E c /
. Please enter here the
]. For stepping to the next
m O 1
[ ] -
2 O
(measuring
:
13