Table of Contents
Advertisement
2.4.6 Analogue output scaling-
The DCS 2-Measuring instrument contains an analogue output (0-1Volt) for each channel. To get the
optimal resolution and accuracy it is possible to scale the analogue output by limiting the measuring
range.
Press [ENTER/MENUE] to change the measuring range (default_ 0..100). Use the up and down
keys [
] to select
On the left corner of the display appears a small 1, which indicates the selected channel. For
changing the channel use the up and down keys [
Press again [ENTER/MENUE] to confirm. On the display appears
To change between measuring range upper limit and measuring range lower limit use the up and
down keys [
= Lower limit (default 00.00)
c @ 0 a
= Upper limit (default 100.00)
c @ 0 D
Press [ENTER/MENUE] to confirm. Use the up and down keys [
digits after decimal point:
= two decimal digits
c O -
= one decimal digit (decimal point moves one digit to the right)
c O -
Press [ENTER/MENUE] to confirm. On the second line of the display appears
and down keys [
= reference standard shows a negative measuring value (below 0,00C°)
R h ^
= reference standard shows a positive measuring value (above 0,00C°)
R h ^ 0
Press [ENTER/MENUE] to confirm. On the second line of the display appears
and down keys [
= below 100,00C°
E c /
= above 100,00C°
E c 0
Press [ENTER/MENUE] to confirm. On the display appears
the up key [
complete then press [ENTER/MENUE] to confirm.
Press [ESC] to return to measuring mode.
For changing the upper measuring range please repeat the above procedure.
DCS 2-menu
Lower limit
dA1b
Upper limit
dA1E
16
c @ B
. Press [ENTER/MENUE] to confirm.
c @ B
] .
] to select the requested range:
] to select the requested range:
] . For stepping to the next number use the down key [
The adjustable measuring range limits are corresponding to the selected
measuring size.
Scale
00.00
10.00
Handling / Introduction
] .
/ / - / /
Meas. range °C
Analogue signal
00,00°C
10,00°C
DigiCal DCS 2
.
c @ 0 a
] to select the number of
. Use the up
R h ^ 0
. Use the up
E c /
. For changing the value use
]. If the requested value is
0,00Volt
1,000Volt
YAME0017/09.10.03
Advertisement
Table of Contents
