Encoded Calibration - M O 0 - Lauda DCS2 Operating Instructions Manual

2.4.3.1 Encoded Calibration -
This calibrating function is only needed in case you would add another probe to the
second measuring channel.
Use the up and down keys [
setting. On the bottom of the display appears a small 1, followed by a four-digit number
(Hex-Code /0..F). The number can be modified with the up key [
use the down key [
Now on the bottom of the display appears a small 2 and after this number a second four-digit number
is displayed. For changing the number please follow the manual as before.
Press [ESC] to get back to the measuring mode.
Important!
After confirming
activated, even though you leave the menu by pressing the [ESC] key
12
m O 0
] to select
]. If the requested number is complete then press [ENTER/MENUE] to confirm.
by pressing [ENTER/MENUE] the function
m O 0
Display-indication with active calibration code
The
B @ K
that
m O 0
Handling / Introduction
. Press [ENTER/MENUE] to confirm the requested
m O 0
– segment and the small 1 on the left indicates to the user
is activated.
DigiCal DCS 2
]. For stepping to the next number
(encoded calibration) is
m O 0
:
m O 0
YAME0017/09.10.03