Recalling The Memory Data (Hold Max Min Ave); Measuring Rate (Fast-Modus); Auto-Off-Function - Lauda DCS2 Operating Instructions Manual

DigiCal DCS 2

2.5 Recalling the memory data (HOLD MAX MIN AVE)

After pressing first time the key [HOLD MAX MIN AVE] the actual value will be hold on the top
display line (big display). pressing again the key [HOLD MAX MIN AVE] the saved maximum-,
minimum and average value will be displayed in the bottom display line (small display).
Clearing the memory (MAX MIN AVE)
Press [CLEAR] key once to erase the stored maximum, minimum and average from memory. On the
display appears
After erasing the memory the instrument automatically switches back to measuring mode indicating
the actual measured value again.
2.6 Measuring rate (FAST-Mode)
Press [FAST/
measurements per second. Press [FAST/
mode (1 measurement per second).

2.7 AUTO-OFF-Function

= Disable Auto-off
c @ m E
= Enable Auto-off
D @ m E
Press [ESC/AUTO-OFF] key again. On the display appears
deactivated.
Press [ESC/AUTO-OFF] key once. On the display appears
automatically after app. 30 minutes.
YAME0017/ 09.10.03
•
Note for 2-channel instruments: First the MAX-MIN-AVE-values of channel 1 will
be displayed – afterwards the values of the channel 2 will be displayed. Is there
only one probe on a 2-channel instrument we suggest to deactivate the channel
without probe.
( 2.4.5 Selection / Channel activation - Chnl)
þ
•
During the recall of the memory data the extremes (MAX MIN) and the average
value (AVE) will not be calculated or carried on.
.
B i p
] key one to change the measuring rate. Now the measuring rate is app. 4
In the fast mode the battery consumption is three times higher than in the standard
mode.
After switching off and on the instrument, the Auto-Off function is automatically
deactivated.
] key again and the instrument is back in the standard
D @ m E
Handling / Introduction
Now the Auto-Off-function is
c @ m E
Now the instrument switches off
17