www.aeroplusrc.com
Landing Gear Assembly
To stop the fuselage getting damaged while the model is assembled we recommend fitting the landing gear first.
Push each axle through the wheel holes, and tighten up with 1x self locking nut and 1x blind nut. Then pass the axle though the hole of landing gear,
and tighten up with 1x self locking nut.
The U/C rakes forward so use the correct wheel pant per side, and using a fine drill, drill holes for the screws.
Now line up the wheel in the centre of the wheel pant opening and tighten the collets. Remember to use nutlock and to make sure the wheel can
move freely.
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com