Monoprice extrusion i3 13860 User Manual page 15

22. Switch the printer on and wait for it to initialize. Select Position > Z. Pos. Fast, then
turn the knob to raise the extruder so that it is at least an inch above the build
plate.
23. Select Quick Settings > Preheat PLA. Note that the screen will not change
immediately, but will return to the home screen and display
bottom after about 30 seconds.
24. Monitor the temperatures of the extruder and plate on the LCD display. When they
reach to within a few degrees of the targets, you are ready to insert filament. (Note
that the display will still show
reached the target values.) Carefully insert the included filament sample into the
hole on the extruder, as shown.
Preheat PLA
, even after the temperatures have
15
Preheat PLA
at the