Monoprice extrusion i3 13860 User Manual page 10

11. You can mount the Filament Stand and Spool Holder onto either the Tower Frame
or the Power Supply/Control Box. Use two hex and the hex wrench to secure it to
your desired location. If mounting it to the tower frame, ensure that the spool
holder is mounted over the center of the tower frame.
12. The cable assembly on the left side of the base has three cables coiled and secured
with a zip tie. Carefully remove the zip tie, then insert the white connector on the
longest of the three cables into the white connector on the bottom of the X-axis
stepper motor.
13. Mate the two-pin black cable connector in the cable bundle with the corresponding
black connector on the cable attached to the stop switch.
10