Table of Contents
Advertisement
THE INSTALLATION SPACE
2-5/16"
cutout width
must be
35-1/2".
10"
84-1/2" max
24" Cutout Depth
83-1/2" min
Finished
Opening
3-1/2"
5"
10"
Water And Electrical Locations
Electrical and water supply must be located as shown.
The cutout depth must be 24"
adjacent cabinetry, depending on your installation.
Allow minimum 1/8" air gap between case back & wall.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed
the 24"
overlaps the bottom of the soffit.
Additional Specifications
An individual properly grounded branch circuit or circuit
breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on rear wall as shown.
Note: GFI (ground fault interrupter) is not recommended.
copper tubing between the cold water line and the
long enough to extend to the front of the refrigerator.
Installation of an easily accessible shut-off valve in the
water line is required.
ZUG2, ZUGSS2 Unified Grille Panel Kit
the installation space must be 71-1/2" wide.
Note: Additional cutout width may be required when side
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width.
must be located as shown.
recommended for each product.
Design Guide
35-1/2"
Finished Width
Wall View
6"
Electrical
Area
75" From
Floor to Bottom
of Electrical Area
Water Supply
3-1/2"
5"
10"
3-1/2"
kit or 1/4" O.D.
™
DIMENSIONS AND CLEARANCES
25-3/8" Framed Models
35"
25-3/4" Stainless Steel Models
Case Width
Case Depth
*83-1/2"
at
Rear
36" Frame to
Frame Width
Depth Including Handles:
26-7/8" Framed Models
27-3/4" Stainless Steel Models
28-11/16" Professional Style Models
Product Clearances
90° if clearance to adjacent cabinets or walls is restricted.
Allow 25" minimum clearance for a full 130° door
swing. Allow 15" for pan removal.
For a 90° door swing, allow 4" min. clearance to a wall,
for framed and stainless steel models. Allow 5" min.
clearance for professional style models. If the 90° door
stop position is used, pan access is maintained, but pan
removal is restricted.
See illustrations pages 4 and 5 to determine door swing
interaction with adjacent cabinets or countertops.
3
refrigerator can be
adjusted to fit into a
cutout that is 83-1/2
*84" From
"
min. to 84-1/2
Floor to
Top Frame
height. Note that the top
case trim at the front is
"
1/2
higher and will
overlap upper cabinetry
legs and wheels for a
"
maximum 1
height
adjustment.
"
max.
Advertisement
Table of Contents
