Table of Contents
Advertisement
STEP 1 REMOVE PACKAGING
CAUTION:
Refrigerator is much heavier at the
using a hand truck, handle from side only.
PRUDENCE:
remove outer carton.
tie-down straps. Remove the ten 5/16" bolts from the
base channels in the tie-downs.
STEP 2 INSTALL WATER LINE
between 40 and 120 p.s.i.
"
tubing between house cold water line and the water
connection location.
the refrigerator. Allow enough tubing to accommodate
bend leading into the water line connection.
NOTE:
™
use any other plastic water supply line because the line
is under pressure at all times. Other types of plastic may
crack or rupture with age and cause water damage to
your home.
™
in the following lengths:
2¢
6¢
15¢
25¢
Shut off the main water supply.
of water.
valve and cold water pipe in a basement or cabinet.
easily accessible.
Installation Instructions
plastic
™
10
Remove 5
base channel
bolts on each
side
Remove 2 strap
bolts on each side
case must be removed before the refrigerator is
tilt refrigerator and slide blocks out from beneath.
Floor
Waterline Tubing
Run about a quart of water through the tubing into
a bucket. Shut off water supply at the shut-off valve.
many water supply kits, but are not recommended
for this application.
NOTE:
are illegal and use is not permitted in Massachusetts.
"
bolts securing the straps
to the skid.
CAUTION:
OFF SKID.
PRUDENCE:
Advertisement
Table of Contents
