GE Monogram ZIC360N RH Design Manual
Built-in bottom-freezer refrigerators
Hide thumbs
Also See for Monogram ZIC360N RH:
- Design manual (20 pages) ,
- Design & installation manual (20 pages) ,
- Installation instructions manual (20 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GE Monogram ZIC360N RH
Summary of Contents for GE Monogram ZIC360N RH
-
Page 1: Installation Instructions
Installation Instructions If you have questions, call 800.626.2000 or visit our website at: www.monogram.com ZIC360N RH, ZIC360N LH, ZICS360N RH, ZICS360N LH Built-In Bottom-Freezer Refrigerators Design Guide With Installation Instructions Monogram. We bring good things to life. ®... -
Page 2: Table Of Contents
If you received a damaged refrigerator, you should immediately contact your dealer or builder. CAUTION: Due to the weight and size of this refrigerator, and to reduce the risk of personal injury or damage to the product - TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION. -
Page 3: The Installation Space
The water line should be 1/4" O.D. copper tubing between the cold water line and water connection location, long enough to extend to the front of the refrigerator. Installation of an easily accessible shut off valve in the water line is recommended. -
Page 4: 130 Door Swing
Refrigerator Top View 130 DOOR SWING (factory setting) Scale 1:1 Design Guide 23-7/8" From Rear of Refrigerator 1" Case 3/4" Trim 1-1/2" 1/2" 1/4" 1-1/4" Door 2" 3" 1-3/4" 2-3/4" 2-1/2" 2-1/4" 1/4" 1/2" 3/4" 1" 3/4" Overlay Panel (Nominal Size) 1/4"... -
Page 5: 90 Door Swing
Design Guide Refrigerator Case Trim 23-7/8" From Rear of Refrigerator 1/4" 1/2" 3/4" 1" 1-1/4" 1-1/2" Door 3/4" Overlay 1/4" Panel Top View (Nominal Size) 90 DOOR SWING 1/2" (optional setting) 3/4" Scale 1:1 1" 1-1/4"... -
Page 6: Customization Basics
ZICS360N RH (right-handed door) ZICS360N LH (left-handed door) Trimmed models: ZIC360N RH (right-handed door) ZIC360N LH (left-handed door) Stainless Steel Wrapped Refrigerators Stainless Steel wrapped refrigerators have wrapped doors and grille panel, beveled edges, and tubular stainless steel handles that coordinate with other Monogram appliances. -
Page 7: Panel Dimensions
1/4" FRAMED PANEL DIMENSIONS If you choose to install framed panels, they must be cut to the dimensions shown. The panels will slide into the frame on the door, drawer and grille. If the custom panel is less than 1/4" thick and if it fits loosely in the door frame, it can be backed up with a piece of filler material or foam tape to improve the fit. -
Page 8: Side Panels
SIDE PANELS Side panels must be used whenever the sides of the refrigerator will be exposed. The 1/4" side panels will slip into the side case trim. Order the side panels from the cabinet manufacturer. * Depending on installation height. -
Page 9: Tools, Hardware, Materials
• Water shut-off valve (optional but recommended) • Custom panels for fresh food door, freezer drawer and grille panel • Screws to secure refrigerator to cabinetry. FLOORING For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. -
Page 10: Step 1, Remove Packaging
• Route 1/4" OD copper tubing between house cold water line and the water connection location. • Copper tubing should be long enough to extend to the front of the refrigerator. Allow enough tubing to accommodate bend leading into the water line connection. -
Page 11: Step 2A, Ro Water Line
Important Note: When the refrigerator is installed under a soffit or if there is not enough height for this method of security, brackets cannot be used. Proceed to step 5 to level the refrigerator and then to step 6 to secure refrigerator to cabinets. The refrigerator must be secured to prevent tipping. -
Page 12: Step 5, Level Refrigerator
Both are accessible from the front of the refrigerator. • To level the back of the refrigerator, turn the 7/16" hex nut located above the front wheels. Turn clockwise to raise or counterclockwise to lower the refrigerator. -
Page 13: Step 7 Adjust Door Swing
STEP 7 ADJUST DOOR SWING NOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130 , you may change the door swing to a 90 opening. Skip this step if door opening is satisfactory for your installation situation. -
Page 14: Step 9 Install Framed Panels
IF YOU ARE INSTALLING OVERLAY PANELS, GO TO STEP 9A. Handle Door Trim Trim Refrigerator Standard supplied handle shown in 1/4" panel position. • There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws in the FRONT screw holes. -
Page 15: Step 9A Install Overlay Panels
REAR screw holes. Discard supplied handle. Installation Instructions Right hand models shown. Use the same instructions for left hand models. Door Trim Handle Trim Refrigerator Door Move Forward For 3/4" Panel Supplied handle shown in the overlay panel position. -
Page 16: Step 10 Connect Water Supply
Electrical Sabbath / Light Outlet Switch • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. • The temperature controls are preset at 37 F for the fresh food section and 0 F for the freezer. - Page 17 Notes...
- Page 18 Notes...
- Page 19 Notes...
- Page 20 Note: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Monogram. ®...