Installation Preparation; Product Dimensions And Clearances; Electrical And Water Connection Location; Accessories - GE ZICS36N LH Installation Instructions Manual

ZICS36N RH
Product
Handle on the left side, the door swings left to
Dimensions
right.
ZICS36N LH
Handle on the right side, the door swings right
to left.
Refrigerators are much heavier at the top than
at the bottom – be extra careful when moving.
Les réfrigérateurs sont beaucoup plus lourds en
haut qu'en bas. Il faut être prudent lors des
déplacements.
These refrigerators are equipped with special
Clearances
hinges that allow the door to swing out and
away from the cabinet. No clearances are
required on the sides.
The water line can be routed through
Electrical and
the floor or back wall.
Water
• Water line should be:
–Approximately 3-1/2" from the floor on the
Connection
Locations
–At least 5" from either side of the opening.
A 115 volt, 60 Hz. 15 or 20 amp power supply
is required. An individual properly grounded
branch circuit or circuit breaker is recom-
mended, as noted on the rating plate. The
rating plate is located on the top on the
evaporator box and is visible when grille
panel is removed.
• Locate the electrical outlet within 5" x 7"
shaded area shown.
–7-1/2" from the left side.
Between 74" and 81" from the floor.
These models are factory set for 84" installation
Accessory
height. Adjustments to 83-1/2" or 84-1/2"
Grille Panel
heights can be made by changing the grille
panel.
Kits
CAUTION
PRUDENCE
back wall, or 3-1/2" from the back wall on the
floor.

Installation Preparation

36" Stainless Bottom Mount Refrigerators
10-3/4" Max.
10" Min.
24-3/4"
26-3/4"
73-1/2"
26"
4"
When the refrigerator is installed in a corner:
• A 4" min. clearance on the hinge side will
assure a 90° door opening and access to all
drawers.
• A 10" clearance on the hinge side is required
for removal of pans.
Electrical Outlet
Location 7-1/2"
5"
3-1/2"
Water Location
Important: To insure a flush fit and access to the power
cord, locate the electrical outlet as shown.
Order ZGCSS36RH (right hand) or
ZGCSS36LH (left hand) Grille Panel Kit.
These kits include 2 grille panels, for 83-1/2"
and 84-1/2" installation heights.
35" Case
36" Overall
84-1/2" Max.
83-1/2" Min.
7"
5"
74"
5