Note: GFI (ground tault interrupter) recollllllended. • Water line can enter the opening floor or back wall. The water line should or GE SlnartConnect O.D. copper tubing between the cold water line and water location, long enough to extend refl'igerator.
Refrigerator Top View 130 ° DOOR SWING (factory setting) Scale 1:1 Design Guide FramelessCabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with 23-7/8"From cabinet door swing. The opening must Rearof allow for filler strips.
Top View 90 ° DOOR SWING (optional setting) Scale 1:1 Design Guide Refrigerator Door FramelessCabinets: The case trim overlaps cabinets atthe top and sides. Therefore, frameless cabinets may require filler Case Trim strips to prevent interference with cabinet door swing. The opening must allow for filler strips.
Page 7
1/4" FRAMED PANEL DIMENSIONS If you choose to install framed panels, cut to tile dimensions shown. Tile panels into tile frame on tile door, drawer If tile custom panel is less than 1/4" fits loosely in tile door fi'ame, it can with a piece of filler...
SIDE PANELS Side panels must be used whenever refrigerator will be exposed. will slip into the side case trim. Secure the refrigerator with stick-on hook strips. Order the side panels fl'om the cabinet ct t II'eI'. I11[I 11{;I • Gilt a notch...
THE POWER CORD. by a DO NOT tile outlet DO NOT APPI,IANCE. REQUIRED 2x4 fl_r Anti-Tip support COl)per water line tubing or GE Refrigerator Tubing tot fl'esh tood door, fl'eezer panel to secure refrigerator to cabinetry: hook loop fastener strips for...
[STEP 2] INSTALL WATER LINE • A cold water suI)ply is required fin" automatic icemaker operation. The water pressure between 40 and 120 p.s.i. OD COl)per or GE Smart(:onnect • Route l/4" plastic tubing between house cold water the water connection location. • Tubing...
N ote:When therefrigerator isinstalled u nder a soffitorif thereisnot enough h eight f orthismethod o f security, brackets cannot b eused. P roceed tostep5 tolevel t herefrigerator andthentostep6tosecure r efrigerator tocabinets. The refrigerator must b esecured to prevent tipping. ANTI-TIP PRECAUTIONS PRECAUTIONS CONTRE LES...
Installation [STEP 5] LEVEL REFRIGERATOR All models have 4-point leveling. rear supported by leveling legs, a_!justable wheels. Both accessible of the refl'igerator. • To level back of the refl'igerator, 7/16" located above clockwise to raise or counterclockwise refl'igera tin, • For...
[STEP 7] ADJUST DOOR SWING NOTE: This refiigerator has a 2-position When space does not allow the door fldlv to 130 °, you may change the door opening. Skip this step if door opening for your installation situation. • i,ift the grille panel to access the wire cover trim.
Instructions PANELS Right hmad models for left hand models. IF YOU ARE INSTALLING GO TO STEP 9A. Handle DoorTrim Trim Refrigerator Door Standardsuppliedhandleshown in 1/4" panelposition. • There are two sets of holes head screws Replace handle screws in the FRONT •...
I/EAR screw holes. Discard supplied Instructions Right hand models for left hm_d models. DoorTrim Handle Trim Refrigerator Door Move Forward For3/4" Panel Suppliedhandleshown in the overlaypanelposition. • There head screws Replace screws in the REAR screw holes.
Insert tmion fitting on the trait and tighten • Tm'n on the water to check fin" leaks. GE SmartCommct'" Tubing: • Insert the molded end of the tubing refrigerator connection. Tighten nut until it is just hand tight.
Installation I STEP 131 INSTALL TOEKICK • I,ocate supplied toekick (shipped side of the refl'igerator), Install provided, a_!iust to desired height screws, • A custom toekick be installed complement surrounding cabinetry, supplied toekick as a template to cut vent holes, SuppliedToekick 1/4"...