FLIR Scout Operator's Manual page 17

Scout Operator's Manual
Power States
•
•
•
•
•
During most use scenarios you will change between Standby and On.
When the camera will not be used for extended periods, you might
consider putting the camera into the OFF state.
Off
On
Standby
431-TS00-00-10, Revision 110
.800.561.8187
Three power states: Off, On, and Standby
The initial power-on Bootup process between the Off state and
the On state takes about 90 seconds (fast flashing red state
LED). During the Bootup process, pressing the Power button
again will turn the camera off. After the camera finishes its
power-on Bootup process, it is in the On state (state LED is off).
After the camera is On, pressing the Power button will toggle the
camera between On and Standby (state LED is flashing slowly).
When battery powered, if Auto-Standby is enabled (see "Auto-
Standby Operation" on page 22), the camera goes to Standby
after three minutes if no buttons are pushed. A warning is shown
in the display.
From the Standby state, the camera comes back on within about
two seconds when the Power button is pushed.
The Auto-Standby function is disabled if the camera is powered
with external power.
Camera
State
The display and the state LED are off
Power-on Bootup—Color bars on the display and the state
LED is flashing quickly
There is a thermal image on the display and the state LED
is off
The display is off and the state LED is flashing slowly
www.
3—Operating Your Scout Camera
How do you know?
information@itm.com
.com
13