Charging The Camera - FLIR Scout Operator's Manual

Scout Operator's Manual
3–3
The batteries in the camera must be fully charged prior to use. If not
fully charged or if the recommended batteries are not installed, the
battery status indicator may not accurately reflect the remaining
battery life. Only use the auxiliary power adapter provided with your
Scout camera.
1. Connect the Hot Shoe to your camera.
2. Rotate the attachment wheel in
3. Plug the power adapter provided
4. Ensure that the plug is fully
Note
The charging indicator will be lit solid green when the Hot Shoe is
not connected to the camera or the recommended batteries are
not installed. Ensure the batteries are charging by verifying the
green blink described above.
431-TS00-00-10, Revision 110
.800.561.8187

Charging the Camera

the clockwise direction until tight.
with the camera into its power
source and also into the Hot Shoe.
seated in the Hot Shoe.
When charging correctly, the
charging indicator will be lit
yellow and will blink green for one
second within about 35 seconds.
The charging indicator will
continue to blink at decreasing
intervals until the batteries are
fully charged.
When fully charged, the charging
indicator will be lit solid green.
The initial charge time is
approximately 4 hours.
www.
3—Operating Your Scout Camera
Plug from power adapter
Charging
indicator
Solid
green
information@itm.com
.com
11