Fitting The Ceramic Fuel Effect - Valor Fires 953 Installer And Owner Manual

2. Swing the bottom control linking bar
towards the centre of the fire to clear the right
side of the fascia. Slide the fascia sideways, if
necessary, to align the bottom fixing holes with
those in the convection box (This will not be
possible on the Dream). Fix the bottom of the
fascia unit to the convection box with two
No.8 x 3/8 screws (See figure 22).
3. Connect the control linkage to the control
pivot plate using the shouldered screw and
using a screwdriver (Not finger tight only) (See
figure 23).
Dream, Eternal and Obsession models only.
1. Supplied with the fire is a self adhesive
control position label. Peel the backing from the
label and place as in figure 24.
Figure 24. Control position label
(Shown with 'Dream' fascia)

12. FITTING THE CERAMIC FUEL EFFECT

The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the fitting guide for the ceramic fuel effect be placed
inside or attached to this guide and handed to the customer following completion of
the 'Final review' section.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Page 29
Figure 22. Fascia bottom location.
Figure 23. Shouldered screw.