Firefront Casting Installation; Fitting The Alpha, Eternal, Elegant And Obsession Firefront Casting; Fitting The Dream Firefront Casting; Fitting The Decadent Firefront Casting - Valor Fires 953 Installer And Owner Manual

13. FIREFRONT CASTING INSTALLATION

13.1 Fitting the Alpha, Eternal, Elegant and Obsession firefront casting.

1. Fit the fire front casting to the fascia. Locate the two screw heads at the rear top
corners of the casting through the keyhole slots at the inner sides of the fascia. If the
screw heads do not project enough or project too far, the screws can be adjusted.
Lower the casting so that it rests on the hearth (See figure 25).
2. Place the bottom front cover casting in position below the fire front casting.

13.2 Fitting the Dream firefront casting.

1. Place the firefront casting centrally on the
hearth in front of the fascia.
2. Place the bottom front cover casting in
position below the firefront casting.

13.3 Fitting the Decadent firefront casting.

1. Check that the two screws in the back of the
fire front casting are in the outer threaded
holes. If they are in the inner holes, relocate
them (See figure 26).
2. Locate the two screw heads through the
keyhole slots at the inner sides of the fascia. If
the screw heads do not project enough or project
too far, the screws can be adjusted. Lower the
casting so that it rests on the hearth (See figure
25).
3. Fit the front cover casting below the front
casting locating it as shown in figure 27.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 27.
Page 30
Figure 25. Firefront casting location
(Shown with Alpha / Elegant casting)
Figure 26. Casting screw
position.