Table of Contents
Advertisement
10.3 Inlet pressure check.
The appliance is pre-set to give the correct heat
input at the inlet pressure shown in section 2 of this
manual. No adjustment is necessary.
1. Check the inlet pressure by fitting a pressure
gauge at the test point. The test point is on the inlet
'T' connector (See figure 19). Check the pressure
with the appliance alight and set at maximum output.
2. After checking, turn off the appliance. Remove the
pressure gauge and replace the test point sealing
screw.
When the above checks from section 10.2
and 10.3 have been completed close the
isolating valve on the inlet 'T' connector.
10.4 Fitting the burner tray trim.
1. Fit the burner tray trim over the front rim of
the burner tray. Push the trim fully down (See
figure 20).
1. Slide the control button upwards as far as it will go. Make sure that the bottom of
the linking bar is higher than the bottom of the
fascia. Place the fascia against the fireplace
front surface so that the two retaining plates at
the back of the fascia are directly above the
two upper retaining brackets at the top of the
convection box. Lower the fascia making sure
that the retaining plates locate fully over the
brackets on the convection box (See figure 21).
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
11. FITTING THE FASCIA
Page 28
Figure 19. Pressure test point
Figure 20. Burner Tray Trim
Figure 21. Fascia location (Shown
with Alpha / Elegant fascia)
Hide quick links:
Advertisement
Chapters
Table of Contents
