Ignition Check; Gas Supply Connection - Valor Fires 953 Installer And Owner Manual

Before attempting to install, it is worth checking that the electronic ignition system
performs satisfactorily.
Fit the battery to the ignition block located below the
burner tray at the left side (See figure 8). The +ve and
-ve terminal positions are marked on the battery holder
body.
Depress the control pivot plate as far as it will go. This
should close the ignition circuit. Sparks should be seen
tracking from the electrode pin to the pilot tip (See figure
9).
If there are no sparks make the following checks.
Check condition of
battery and that it is
correctly
If the above is
satisfactory, check the
ignition circuit and
components - see the
servicing and parts
replacement section in
this guide.
A nut and olive are provided for an 8mm pipe inlet connection to the inlet 'T'
connector at the bottom front of the appliance. The inlet 'T' connector can be rotated
to allow a connection from any direction. The inlet 'T' connector includes a valve for
isolating the gas supply and a pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed supply pipe connection.
If a concealed connection from inside the fireplace is required then, before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the convector box and run to the
inlet 'T' connector at the front. The pipe run from the supply line up to the rear
opening in the convector box must be kept away from the area which will be taken by
the convector box when it is installed. Note that the centre of the appliance inlet 'T'
connector is 25mm above the fireplace floor. The inlet 'T' connector should be fitted to
the supply pipe at this stage.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE

6. IGNITION CHECK

Figure 9. Slider control

7. GAS SUPPLY CONNECTION

Page 22
Figure 8. Fitting battery