Modem Module Cable - HP Compaq 6735b Maintenance And Service Manual

3.
Reverse this procedure to install the SIM connector board.

Modem module cable

NOTE:
Before removing the modem module cable, follow these steps:
1.
2.
3.
4.
5.
Remove the modem module cable:
1.
2.
Downloaded from www.Manualslib.com
Remove the SIM connector board (3) by sliding it forward and out of the base enclosure.
The modem module cable is included in the Cable Kit, spare part number 487138-001.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
Remove the battery (see Battery on page
Remove the following:
a. Hard drive (see Hard drive on page
b. Optical drive (see Optical drive on page
c. Keyboard (see Keyboard on page
d. Switch cover (see Switch cover on page
e. Display assembly (see
f. Top cover (see Top cover on page
g. Rear cover (see Rear cover on page
Disconnect the modem module cable (1) from the system board.
Remove the modem module cable (2) from the clips and routing channel (3) built into the system
board bracket.
manuals search engine
47).
53)
56)
61)
66)
Display assembly on page
81)
92)
75)
Component replacement procedures 95