Modem Module Cable - HP ProBook 6455b Maintenance And Service Manual

Modem module cable

NOTE: The modem module cable is included in the Cable Kit, spare part numbers 613352-001.
Before removing the modem module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bluetooth module (see
b. Mass storage device (see
c. Optical drive (see
d. Keyboard (see
e. Switch cover (see
f. Fan (see
g. Heat sink (see
h. Palm rest (see
i. Display assembly (see
j. Top cover (see
k. ExpressCard assembly (see
l. Speaker assembly (see
m. Card reader/USB board (see
n. System board (see
Remove the modem module cable:
1. Release the RJ-11 connector (1) from the clip built into the base enclosure.
2. Release the modem module cable from the clips (2) and routing channel built into the base
enclosure.
Battery on page
Bluetooth module on page
Mass storage device on page
Optical drive on page
Keyboard on page
Switch cover on page
Fan on page 102)
Heat sink on page
Palm rest on page
Display assembly on page
Top cover on page
ExpressCard assembly on page
Speaker assembly on page
Flash media/1394 board on page
System board on page
74).
76)
88)
90)
97)
104)
100)
108)
120)
129)
134)
Component replacement procedures 141
78)
125)
132)