Advertisement
Quick Links
Quick Start Guide for -PB2 Point-to-Point Networks
This Quick Start Guide describes how to replace discrete and analog signal wires using one Node and one Gateway when using the
DX80G2M6S-PB2 Gateway's DIP switch-based mapping.
Step 1: Set the Gateway's DIP Switches
In the example network shown, the Node and Gateway are a mapped pair. To configure this I/O mapping, set the Gateway's DIP switch 2 and
switch 8 ON. Refer to the Gateway's datasheet for other mapping options and the link loss settings.
Step 2: Wire the Node and Gateway
Wire the power, discrete I/O, and analog I/O on the Node and Gateway according to the wiring diagram shown.
I/O Mapping
Node Inputs
Analog IN 1
Analog IN 2
Discrete IN 1
Discrete IN 2
Gateway Inputs
Analog IN 1
Analog IN 2
Discrete IN 1
Discrete IN 2
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Node Model
DX80N2X6S-PB2
1
2
8
3
4
5
1
6
DIP switches
LED
Gateway Output
Analog OUT 1
Analog OUT 2
Discrete OUT 1
Discrete OUT 2
Node Outputs
Analog OUT 1
Analog OUT 2
Discrete OUT 1
Discrete OUT 2
10-30V dc
Gateway Model
DX80G2M6S-PB2
1
OFF
ON
2
8
3
4
5
1
6
DIP switches
Node and Gateway Wiring
AI1
−
+
AI2
DI1
DI2
GND
DO1
Load
DO2
Load
AO1
AO2
485+
RS-485 +
485−
RS-485 −
GND
−
PWR
+
GND
LED
Binding button
1
2
8
3
4
Antenna connection
5
1
6
DIP switches
LED
7
8
9
10
Tens unit
11
Ones unit
12
Rotary dials
13
14
Hole for #6 screw (3)
Advertisement
Related Manuals for Banner DX80N2X6S-PB2
Summary of Contents for Banner DX80N2X6S-PB2
- Page 1 DX80G2M6S-PB2 Gateway’s DIP switch-based mapping. Node Model Gateway Model DX80N2X6S-PB2 DX80G2M6S-PB2 Step 1: Set the Gateway’s DIP Switches In the example network shown, the Node and Gateway are a mapped pair. To configure this I/O mapping, set the Gateway’s DIP switch 2 and switch 8 ON.
- Page 2 Quick Start Guide for -PB2 Point-to-Point Networks Step 3: Bind the Node to the Gateway 45.72 [1.8”] 30.48 Binding Nodes to their Gateway ensures the Nodes only exchange data with the Gateway [1.2”] they are bound to. To create your network, bind the Nodes to the Gateway and assign them a unique Node address.