Daikin BRC2E52C7 Installation Manual page 42

Other Service Settings
18-4 Outdoor Unit Status
● Consult the outdoor unit thermistor temperatures.
Th1
Th2 Heat exchanger thermistor
Th3
Th4
Th5
Th6
18-5 Forced Fan ON
● Force the fan(s) ON for the individual indoor units.
● This function can be used to check which indoor unit number is associated with which indoor
unit.
18-6 Switch Main Sub Controller
● Swap the main and sub remote controller designation.
NOTE
● Changing the main/sub designation requires to turn the power OFF and ON again.
18-7 Filter Indicator
● Resets the timer of the filter indicator for all indoor units.
18-8 Test Filter Auto Clean
● Test if filter auto clean works.
● This function is only available if the Self Cleaning Decoration Panel is installed.
● When Filter Auto Clean is disabled (Disable Filter Auto Clean), the message "Auto filter clean
is disabled" will be shown when opening the Test Filter Auto Clean screen.
18-9 Brush/Filter Ind
● Resets the timer of the filter indicator for all indoor units.
● This function is only available if the Self Cleaning Decoration Panel is installed.
18-10 Disable Filter Auto Clean
● Enable/disable the use of the Filter Auto Clean function.
● When disabled, the message "Auto filter clean is disabled" will be shown when opening the
Test Filter Auto Clean and Filter Auto Clean screen.
● This function is only available if the Self Cleaning Decoration Panel is installed.
Installation manual
41
SkyAir
Outdoor air thermistor
Discharge pipe thermistor
-
-
-
VRV
-
-
-
-
-
-
BRC2E52C7 / BRC3E52C7
4P368041-1
–
2014.02