Daikin BRC2E52C7 Installation Manual page 10

Remote controller installation procedure
Switchbox
(field supply)
(Use optional accessory
KJB111A)
CAUTION
● Select a flat surface for installation if possible.
● Do not tighten the installation screws too much to avoid deforming the lower case.
3-6 Attach the upper case.
● Align the upper case with the tabs of the lower case (6 points) and insert the upper case.
● Be careful not to pinch the wiring when attaching.
● Peel off the protective seal which is attached to the upper case.
3-7 Remove the upper case.
Insert a slot screwdriver into the slots in the lower case (2 places) to remove the upper case.
NOTE
● The remote controller PCB is installed on
the upper case. Be careful not to damage
the PCB with the slot screwdriver.
● Take care that dust or moisture does not
touch the PCB of the removed upper
case.
Installation manual
9
Small screws (M4×16)
Screwdriver
Switchbox for one unit
(with no cover)
84
28
(Installation pitch)
Insert and twist the screwdriver
lightly to remove the upper case.
BRC2E52C7 / BRC3E52C7
Upper case
Lower case
–
4P368041-1 2014.02