Internal Usb Memory Key (Optional); Replacing The Optional Internal Usb Memory Key - Dell PowerEdge R330 Owner's Manual

3. If installed, remove the cooling fan blank.
4. If required, remove the cooling shroud.
Steps
1. Lower the fan into the cooling fan bracket.
2. Connect the power cable to the power cable connector on the system board.
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in
Related Tasks
Removing the cooling fan blank
Removing the cooling shroud
Installing the cooling shroud

Internal USB memory key (optional)

The USB memory key installed inside your system can be used as a boot device, security key, or mass
storage device.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify
the USB memory key in the boot sequence in System Setup.
The internal USB connector is located on the system board.
Related References
System board connectors

Replacing the optional internal USB memory key

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Remove the expansion card riser.
Steps
1. Locate the USB connector or USB key on the system board.
To locate the USB connector, see
2. If installed, remove the USB key from the USB connector.
3. Insert the replacement USB key into the USB connector.
82
After working inside your
Safety instructions.
Before working inside your
System board connectors.
system.
system.