Installing The Power Interposer Board - Dell PowerEdge R330 Owner's Manual

Figure 60. Removing and installing the power interposer board
1. standoffs (2)
3. power interposer board
5. 28 pin cable to system board
7. 8 pin cable to system board
NOTE: For systems without a hard drive backplane, do not connect the 10 pin cable.
Next steps
1. Install the power interposer board.
2. Follow the procedure listed in
Related Tasks
Removing a redundant power supply unit

Installing the power interposer board

Installing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
After working inside your
2. 10 pin cable to hard drive backplane
4. screw (2)
6. 4 pin cable to system board
system.
125