Installing The System Board - Dell PowerEdge R330 Owner's Manual

Removing a cooling fan
Removing an expansion card
Removing the expansion card riser
Removing the optional iDRAC port card
Removing the heat sink
Removing the processor
Removing the optional internal dual SD module

Installing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be
performed only by Dell certified service technicians.
CAUTION: Do not lift the system board by holding a memory module, processor, or other
components.
CAUTION: Take care not to damage the system identification button while placing the system
board into the chassis.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Hold the system board by its edges, and orient it toward the back of the chassis.
2. Lower the system board into the chassis until the connectors at the back of the system board align
with the slots on the back of the chassis.
3. Tighten the screws that secure the system board to the chassis.
Next steps
1. If required, install the Trusted Platform Module (TPM). See,
2. Reinstall the following components:
a. expansion card riser
b. memory modules
c. heat sink and processor
d. cooling shroud
e. iDRAC port card, if removed
f. internal dual SD module, if removed
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed through the cable routing latch.
4. Follow the procedure listed in
5. Import your new or existing iDRAC Enterprise license. For more information, see the Integrated Dell
Remote Access Controller User's Guide, at Dell.com/idracmanuals.
130
Safety instructions.
Before working inside your
After working inside your
system.
Installing the Trusted Platform
system.
Module.