Intrusion Switch; Removing The Intrusion Switch - Dell PowerEdge R330 Owner's Manual

Intrusion switch

Removing the intrusion switch

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Remove the cable from the cable routing latch.
3. Using a plastic scribe, slide the intrusion switch and remove it from under the intrusion switch slot.
Figure 14. Removing and installing the intrusion switch
1. intrusion switch
3. intrusion switch cable
5. cable routing clip
Safety instructions.
Before working inside your system.
2. intrusion switch slot
4. intrusion switch connector on the
system board
51