Jacobsen HR9016 Turbo Safety, Operation & Maintenance Manual page 37

6.2.17 WEIGHT TRANSFER KNOB _________________________________________________
The weight transfer knob adjusts the weight of the cutting units to increase or
decrease the mower traction. When you adjust the weight transfer knob, the lower
time of the cutting units will change and increase or decrease the ground pressure at
each tire.
Rotate the weight transfer knob to the left side to increase the cutting unit weight and
decrease the mower's traction. The time needed for the cutting units to lower will
decrease.
Rotate the weight transfer knob to the right side to decrease the cutting unit weight
and increase the mower's traction. The time needed for the cutting units to lower will
increase.
If the cutting unit weight is set too low, the wing cutting units will not lower to the
ground.
6.2.18 PANEL LATCH ___________________________________________________________
The panel latch holds the control panel closed while the mower is in operation. Rotate the latch
90° to open the panel to access the fuses and relays.
6.2.19 REVERSE ENGINE FAN SWITCH ____________________________________________
The reverse engine fan is an optional accessory. When the switch is pressed, the fan blades will rotate
to the reverse position to blow grass and other debris off the radiator screen. When the switch is
released, the fan blades will rotate to the normal operation position.
Press and hold the front of the reverse engine fan switch for 5 to 10 seconds to blow grass and other
debris off the radiator screen.
NOTICE
CONTROLS 6
en-36