Hisun HS 400 Owner's Manual page 24

① Seat belt
2. Selecting light switch position.
■ Head Light Switch
Turn on the key switch and turn the head light
switch to the "ON" position.
Turn the head light switch to the "OFF" position to
turn off the head light.
① Head light switch
② Head lights "OFF"
③ Low Beam headlight "ON";
④ High Beam Headlights "ON";
⑤ 4WD button
⑥ 2WD button
NOTE：
Turning the head light switch to the "ON" position
causes the following lamps to light simultaneously.
1. Tail lights (lamps at the rear portions of the
vehicle)
2. Lamp built in the coolant temperature gauge
3. Lamp built in the fuel gauge
4. Lamp built in the speedometer
OPERATING THE VEHICLE 8-2
■ Hazard Light Switch
[if equipped]
Press the top half of the hazard light switch, the
hazard lights flash along with the indicator on the
instrument panel. Press the bottom half of the
hazard light switch to turn off the hazard lights.
Note:

The hazard light switch is operative when the
key switch is in the "ON" or "OFF" position.
Be careful that keeping the switch "ON"
causes the battery to run down.
■ Turn Signal Light Switch
[if equipped]
To indicate a right turn, push on the lower half of
the turn toggle switch.
To indicate a left turn, push on the upper half of the
turn toggle switch.
When the left or right signal is activated, the
indicated turning light will flash and the other will
stay on.
The indicator lamp at the instrument panel also
flashes indicating the direction of the turn.
NOTE:

The turn signal light switch is only operative
when the key switch is in the "ON" position.
If the hazard light switch is pressed to the
"ON" position while the turn signal is activated,
the indicated turning light will flash and other
will stay on.

Be sure to return switch to center position after
turning.