Low Level Programming; Temperature Display; Password - Pitco W14S-S WF Installation, Operation And Maintenance Manual

2.3.2 Low Level Programming

In addition to the basic programs there are a number of low level programs. These functions are used to set
the features of the computer that do not need to be changed often. These functions are:
•
Temperature System °C or °F
•

Password

•
Volume
•
Language
•
Melt Cycle Setting
•
Recovery Test
•
Computer Control Mode
To enter the lower level programming level and change the desired function, use the procedure for the
function to be changed.

2.3.2.1 Temperature display

To toggle between °C and °F use the following procedure:
1. Press the Program key
are still in the low level programming mode from a previous procedure you will not need to enter the
password.
2. Press the zero (0) product key. The display will change to show "SELECT".
3. Next press the one (1) product key to enter the temperature program. The display will indicate the current
temperature units "DEGREE F" (DEGREE C).
4. To change the temperature units press the zero (0) product key. The display will alternate between
"DEGREE F" and "DEGREE C" each time the zero (0) key is pressed.
5. To exit the temperature display setting program press the Program key
program mode. To exit programming mode press the Program key
2.3.2.2 Password
To set a new password or remove the password follow the procedure below:
1. Press the Program key
are still in the low level programming mode from a previous procedure you will not need to enter the
password.
and enter the password (if a password is programmed). If you
and enter the password (if a password is programmed). If you
2-8
to return to the
again.