Programming The Intellifry Computer; Basic Programming; Programming Shortening Temperature - Pitco W14S-S WF Installation, Operation And Maintenance Manual

2.3 PROGRAMMING THE INTELLIFRY COMPUTER

There are three levels of programming for the new computer, user, service, and factory. Each level allows
for different degrees of computer control. Only the user level of programming is discussed in detail in this
section. The service and factory levels of programming deal with the configuration of the computer and
require an additional password to enter. The user programming section is broken down into two section
basic and infrequent.

2.3.1 Basic Programming

There are only two items that will be changed on a routine basis, shortening temperature and product times.
If a password is programmed you must enter the password to change the program in the computer.

2.3.1.1 Programming Shortening Temperature

NOTE
Skip step one if you are still in the program mode from a previous procedure. By remaining in
the program mode you will not need to reenter the password.
1. Press the Program key
PROGRAM. If a password is required the display will change to PASS_ _ _ _indicating that you
must enter the password. Enter the password to access the user level programming mode.
2. Press the Temperature key
will be displayed. If the current temperature setting is correct
press the Program key
3. Enter the new shortening temperature by pressing the product number keys for the desired
temperature. For instance if you want the new temperature to be 350°F, you would press the 3, 5,
and 0 product keys.
4. The new temperature will be shown in the display. To exit the temperature program and save the new
setting press the Program key
You can go to the next item to be changed or exit the programming mode. To exit the programming
mode press the Program key again.
If no password is programmed the display will indicate
. The current set temperature
return to the programming mode.
You will still be in the user programming mode.
2-6