Table of Contents
Advertisement
VNC hotkey selection
During a VNC session, you can use hotkey presses to quickly display the Host
selection menu or to choose a host by its port number:
To select a computer using hotkeys
1
Simultaneously press and hold
Note: The
and
keys when pressed in combination are called
'hotkeys' and they signal to the SC5-4xIP that you wish to control it, rather
than the computer. However, if these particular hotkeys clash with another
device or program, then your administrator may change them to a different
combination. If the
combination fails to work, then please contact
the system administrator for details.
Note: VNC hotkeys are set separately to the hotkeys used by the locally
connected keyboard. For details about changing the VNC Viewer hotkeys,
Appendix 2: Unit
Configuration.
see
2 While still holding
and
, press the first numeral of the required port
address, then:
• If the port address is a single character, release all of the keys.
• If the port address is two or more characters, release the first numeral
key and press the second – repeat this procedure until all of the port
address numerals have been entered, then release
Note: The numbers on your keyboard's numeric keypad are not valid, use
only the numeral keys above the QWERTY section.
Note: If you do not have authorisation to view the selected port then a
message will be displayed to explain your lack of access rights.
Note: When using hotkeys, the leading zeros for all single digit port
numbers (including all cascade levels) are optional, i.e. 01, 02...09.
and
.
and
.
Standard hotkeys
The range of hotkey combinations are as follows:
Note: If your hotkeys have been changed, substitute them for
the examples given here.
Selects port 1
Selects port 2
•
•
•
•
then
Selects port 10
Note: When entering multiple digit addresses as
above, keep
other numbers have been entered.
Selects no host
Displays the Host Selection menu so that you
may choose a host by name.
and
in
and
pressed down until all
Advertisement
Table of Contents
