Keyboard Hotkey Selection - Lindy 32503 User Manual

English Manual

Keyboard Hotkey Selection

You can also conveniently select the computer to be accessed and displayed by switching ports
through simple keyboard key sequences. To send commands to the KVM switch, the "SCROLL
LOCK" key must be pressed twice within 2 seconds. You will hear a beep to confirm that the
keyboard is in hotkey mode. If you have not pressed any key in hotkey mode within 2 seconds,
the keyboard will return back to Operating System control status.
Direct Port Selection / Keyboard Hot Key Commands:
Within 2 seconds
+
Scroll Scroll
Lock Lock
+
CPU Switch/Bank Selection:
The CPU Switch P-Series/PXT range supports cascading of up to 8 CPU Switches (Banks).
Therefore, when using direct hotkey port selection you must include the key sequence for the
CPU Switch/Bank:
Scroll Scroll
+
Lock Lock
Example: To access a computer attached to Port 6 of the first CPU Switch you should
press the following hotkeys:
Scroll Scroll
+
Lock Lock
To use hotkey switching to access another CPU Switch / Bank:
Scroll Scroll
+
Lock Lock
Scroll Scroll
+
Lock Lock
↑
+ = Previous Port
or
↓
+ = Next Port
Bank
+
No 1~8
+ +
1
Page
+ =
Up
Page
+ =
Down
Port No.
01~04 (4 port)
+
01~08 (8 port)
01~16 (16 port)
+
0 6
Previous Bank
This will only work if a daisy
(
chained CPU Switch is present)
Next Bank
11
Tip: Hold the arrow key down,
or press multiple times, to cycle
through the ports
Important Note:
Always keep in
mind to include
leading zeros for
all ports below 10!
i.e.104 for Port 4 of
the first Switch.
Bank no. and
Port no. selection
must be made
using the
numeric keys on
the keyboard.
Keys on the
numeric keypad
are not available
as hot key
commands!